M1000
The electromagnetic flowmeter ModMAG M1000 has been designed for applications in machinery plants, vehicles and batching processes in the range from DN 6 to DN 200 with a variety of process connections such as DIN flanges, dairy pipe connections, TriClamp, etc.
The basic line of M1000s is provided with a 24 VDC power supply without display, with passive outputs, and can be programmed via a serial RS-232 port or via a separate handheld device. The instruments can also, upon request, be factory preconfigured and then just need to be electrically connected on site.
M2000
The amplifier type ModMAG M2000 is best suited for bidirectional flow measurement of fluids with a conductivity greater than 5 μS/cm (> 20 μS/cm for demineralised water). Instruments in the M2000 series show high accuracy, are easy to use and can be chosen for a large and flexible applications spectrum.
The backlit, four-line display shows all actual flow measuring data, daily and complete information, including alarm messages. The standard amplifier has four programmable digital outputs, one digital input, power output and USB interface. Integrated test tools make the setup, operation and service easier.
M3000/M4000
These new electromagnetic flowmeters with modular design allow flow measurements in Ex zones 1 and 2, in either the mounted or remote version. The amplifier housing, made of powder-coated aluminium, is available in protection class IP67 and with a separate connection space.
Programming can be done either with closed housing, thanks to a magnetic pen, or with open housing via three buttons. The four-line display shows all necessary data like actual flow, totaliser and status messages. The programmable excitation frequency even enables the amplifier to be adjusted for difficult metering applications. The newly developed process for amplifier compensation enables a high accuracy, especially in the lower flow range.
M5000
The B-MAG M5000 is a battery-powered electromagnetic flowmeter with very high accuracy even at low flows. The excellent repeatability as well as the above average battery life makes this innovative water meter indispensable to the water industry. Typical applications are leak detection in water networks, water consumption measurements and irrigation plants.
The meter is best suited for applications without a power supply, where exact consumption or flow rates are required. The meter can be powered with mains voltage, and in case of a mains failure, the internal battery takes over. All instruments are designed to comply with OIML R49-1 and MID MI-001.
For more information contact Sean Frost, Dupleix Liquid Meters, +27 (0)11 457 0500, [email protected], www.dlm.co.za
| Tel: | +27 11 457 0500 |
| Email: | [email protected] |
| www: | www.dlm.co.za |
| Articles: | More information and articles about Dupleix Liquid Meters Flow Control (DLM) |
© Technews Publishing (Pty) Ltd | All Rights Reserved
printer friendly version